Blot the area dry with a micro fiber towel and re-wet with water between coats. Put a little more of the dark color in areas of damage, or where heavier rust might appear. This is more like applying overspray, with uneven coverage. Over that, I literally take a squirt bottle of water and wet a small area, while simultaneously spraying in a very light coat of the dark brown. I started in with a single coat of red oxide color, over the areas that I would eventually want the rusty patina to appear. This truck was purple and in pretty good condition. If a guy wanted, a topcoat of matte clear could be added for more protection. It takes more than a few cans to do an entire vehicle, but this process is only adding a thin level of coverage. My topcoat color is red, and I used gloss for the that. If you can find satin or matte colors, even better. Oh, also I should note that this is done entirely with spray paint, just regular old bomb cans! The colors for the rust effect are reddish brown, a dark mocha color and bright orange. It's backyard faux patina that you can pull off at home, over the weekend, for a couple hundred bucks. Now, this is by no means a concourse level paint job. I am skipping past the most basic parts, like sanding and prep or any kind of metal fab or repair. Oh, and if you're a faux patina hater, just move along. Hopefully others can chime on on this thread as well, if they have any tips or tricks they use. It is only slightly more involved and 100% achievable for a backyard guy, that doesn't want to spend 25 grand on a concourse level paint job for his project car. Buuuuut, Where is the texture? Where is the rust? Where is the faded portion? Where is the drama? So, I thought I would do a quick post on how I do mine. Something that every guy can actually pull off in his garage with very limited skill and equipment. I think it's awesome that guys are doing something outside of the conventional approach to hot rodding. It's become cliche at nearly every car show and rod run that we attend. We have all seen vehicles covered with primer, then a thin layer of paint, that then has every edges, nook and cranny sanded off, to resemble patina. I have had a lot of people asking about my approach at faux patina.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |